+606 232 5821 sales@central-cables.com.my
Knowledge Sharing

Batch 1.0 bagi program “Knowledge Sharing” bersama pelajar-pelajar Fakulti Kejuruteraan Elektrik, UTeM Melaka

9 Mar 2020 | Central Cables Berhad Batch 1.0 bagi program “Knowledge Sharing” bersama pelajar-pelajar Fakulti Kejuruteraan Elektrik, UTeM Melaka. Selaras dengan slogan Central Cables “Central to Nation’s Growth”, program ini bertujuan untuk berkongsi ilmu bersama pelajar-pelajar IPTA/IPTS tentang kabel kuasa.  9,534 total views

 9,534 total views

Part 2 (a) – Insulation

There are many types of electrical insulation in use today, with each having unique physical and chemical properties. Most common insulation materials used in electrical cables are made from plastic-polymer-based compounds. Ever wondered why bare conductors used in high voltage transmission systems do not have any insulation? The answer: air is natural insulation between phase-to-phase…

 23,426 total views

Part 1 (i) – Conductor

Copper and aluminium are primary choices of material for cable conductors due to its mechanical, electrical properties and of course price of the commodity itself. The table above show the comparison between various metals according to the International Annealed Copper Standard (IACS). The diagram on the right illustrates that different material due to different conductivity…

 89,087 total views

Part 1 (h) – Conductor

The routine test shall be tested on conductor to determine the DC resistance of the conductor at 20 oC and the measured value shall not exceed the appropriate maximum specified in table of IEC 60228 and BS 6360. This type of test is done on a 1 meter sample in a laboratory using a double…

 143,107 total views

Part 1 (g) – Conductor

Current carrying capacity depends on the cross-sectional area of the conductor and the material it is made from. The complexity of cable routes and environmental constraints such as burial depth, type of soil will also influence the current rating. It is often referred to as “derating factor”. Therefore engineers and designers, when calculating power load…

 205,853 total views

Part 1 (f) – Conductor

Almost any type of copper or aluminium conductor produced today undergoes concentric stranding to build up to a desired cross-sectional area. For instance it is much more practical and cost effective to produce a 19-wire 35mm2 conductor than to produce a single solid 35mm2 conductor.  100,305 total views

 100,305 total views

Part 1 (e) – Conductor

Calculating conductor weight is fairly straight forward. No complex formulas here. Simply multiply the conductor cross-sectional area by the material density of that conductor.   Disclaimer: Our product knowledge sharing series is intended for information and educational purposes only. It shall not be construed as a technical guide or guarantee on our part. If you…

 81,071 total views

Part 1 (d) – Conductor

Last week’s post, we shared the composition and material density of copper, aluminium and aluminium alloy. That determines the strength and conductivity of each material. The chart above shows the comparison between copper and three different grades of aluminium. The unique properties of each grade of material makes it suitable for different uses. For instance:…

 189,822 total views

12